Shrinkage Prevent Agent for Gravity Casting
PROBAT-FLUSS MIKRO 100
Agent to prevent shrinkage holes and the formation of homogenously distributed micro pores.
applicable for all casting alloys in the sand casting, gravity die casting and low-pressure casting
Applicati on Range:
PROBAT-FLUSS MIKRO 100 can be added to the crucible, the launder or the runner after the cleaning of the melt.
The rod dissolves immediately without any residues. A thorough mixing of the melt after the last cleaning process has proved to be very effective.
Quality Characteristics:
• is a metallic master alloy in form of rods
• does not require long reaction times
• impedes the shrinkage hole formation in the gravity die and sand casting
• leads to fine micro pores
• increases the density index without contribution to impurities
• dissolves immediately in the melt without any residues
Addition Rate:
1–3 kg/t of the metal mass, depending on the alloy. As a general rule 1 kg/t has proved to be very effective.
Product Application:
PROBAT-FLUSS MIKRO 100 can be used in the pouring furnace, in the crucible or in the ladle.
After the last cleaning process it must be added to the melt and the foam, which can partially form, must be thoroughly stirred into the melt by means of a ladle otherwise the effectivity is reduced. The effect lasts over several hours and is also remarkable after a remelting process. After an intensive cleaning, the melt is in its original condition again.
Typical Properties:
Appearance: aluminium rod
Odour: odourless
Reacti on temperature: from melt temperature
Packaging:
Rods of 1m of length (approximately 300 g)
loose rods, bundled
Storage and Shelf Life:
No special requirements
Name: Goffy
Mobile:+86-21-8037 0639
Tel:+86-21-8037 0639
E-mail:[email protected]
Add:Room 514 No 36, Lane 159 Nianjiabang Road, Pudong, Shanghai 201417